HP Compaq dx7200 MT Reference Manual page 167

POST Error Messages (Continued)
Screen Message
207-ECC Corrected
Single Bit Errors in
DIMM slot(s)
213-Incompatible
memory Module in
memory Socket(s)
X,X, X
214-DIMM
Configuration Warning
216-Memory Size
Exceeds Maximum
Supported
219-ECC Memory
Module Detected. ECC
Modules not supported
on this platform
301-Keyboard Error
303-Keyboard
Controller Error
Service Reference Guide, dx7200
Probable Cause
Memory module is
experiencing correctable
errors.
A memory module in
memory socket identified
in the error message is
missing critical SPD
information, or is
incompatible with the
chipset.
Populated DIMM
configuration is not
optimized.
Recently added memory
module(s) exceeds the
supported memory
amount for the system.
Recently added memory
module(s) support ECC
memory error correction.
Keyboard failure.
I/O board keyboard
controller.
390812-001
POST Error Messages
Recommended Action
If additional memory was recently
added, remove it to see if the problem
remains.
If memory module was not recently
installed and frequency of error message
increases, consider replacing the
module.
Check product documentation for
memory support information.
Verify proper memory module type.
Try another memory socket.
Replace memory with a module
conforming to the SPD standard.
Rearrange the DIMMS so that each
channel has the same amount of
memory.
If additional memory was recently
added, remove it to see if the problem
remains.
Check product documentation for
memory support information.
If additional memory was recently
added, remove it to see if the problem
remains.
Check product documentation for
memory support information.
Reconnect keyboard with computer
turned off.
Check connector for bent or missing
pins.
Ensure that none of the keys are
depressed.
Replace keyboard.
Reconnect keyboard with computer
turned off.
Replace the system board.
C–3