Table of Contents
Advertisement
Figure 13-1: Battery Terminals Connected with the Terminal Linking Bar
5. Connect the positive ring tag from the housing MCB to the positive terminal of
Battery 4. (brown cable)
6. Replace the battery retention bar.
After Replacing the Battery Pack:
1. Plug the 48V Battery Connector back into the FXM Unit
2. Switch all Breakers on the Battery Shelves (Battery Housing Assemblies) in both
cabinets (UPS and Battery Expansion Cabinets) to the ON position
3. Switch the Battery Breaker on the Front left of the Alpha FXM UPS unit to the ON
position
Finally check that there are no alarms active on the UPS and that the UPS is in Line
mode.
Version
7
Last Editor
Ore Oluwatudimu
Document
UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
Infrastructure and Mobility, Traffic Solutions
Page 62 of 76
Status
TS008468
Date
Doc. No.
Sopers Lane, Poole, Dorset
BH17 7ER
ISSUED
31/01/2017
667/HB/47750/000
Advertisement
Table of Contents
