HP Compaq dc7100 DT Getting Started Manual page 16

Getting Started
4. Position the computer on its side with the rubber pads on the
bottom. (If the computer is being used in the tower
configuration, remove the computer from the stand.
5. Loosen the thumbscrew on the rear of the computer, slide the
access panel toward the rear of the computer, then lift it off.
6. Push the tongue of the catch down 1 and slide the catch
toward the right side of the computer 2 until it is disengaged.
Releasing the MultiBay Security Catch
7. Replace the access panel.
8. Replace the stand, if desired.
12 www.hp.com Getting Started