Stiga MPST 84 Li 48 V1 Operator's Manual page 100

NOTE
The jack positioned in this way makes it
possible to lift the entire front axle.
9.3.4 Changing the wheel
SAFETY INSTRUCTION
Make sure that the machine remains still
and stable during the lifting process. If you
notice anything out of the ordinary, lower
the jack immediately, check and resolve
any problems and lift the machine again.
1. Remove the cover (fig. 39.A).
2. Raise it enough to extract the wheel easily.
3. Use a screwdriver to remove
the snap ring (fig. 39.B) and the
shoulder washer (fig. 39.C).
4. Remove the wheel to be changed.
5. Smear the axle (fig. 39.D) with grease.
6. Mount the spare wheel.
7. Carefully replace the shoulder
washer and snap ring.
NOTE
Check that the two rear wheels are the same
height (fig. 40.A) and that the difference
between the external diameters of the
two wheels (fig. 40.B) is no greater than
8-10 mm. On the contrary, to avoid uneven
mowing, the cutting means assembly must be
aligned by an Authorised Service Centre.
9.3.5 Repairing or changing tyres
The tyres are "Tubeless" and so all punctures
must be repaired by a tyre repairer following
the procedures required for this type of tyre.
9.4 REPLACING LED LAMPS
9.4.1 LED TYPE I
Loosen the lock nut (fig. 41.A) and remove the
connector (fig. 41.B). Remove the LED illuminator
(fig. 41.C), secured by screws (fig. 41.D).
9.4.2 LED TYPE II (bayonet type)
The bulbs have a bayonet fitting and are installed
in the bulb holder, which can be taken out by
turning it anti-clockwise with pliers (fig. 42).
10. STORAGE
When you intend to put your machine
away for more than 30 days:
1. Remove the ignition key.
2. Clean the machine thoroughly.
3. Check the machine for any
damage. If necessary, contact the
authorised service centre.
4. Store the machine:
• with the cutting means assembly lowered
• in a dry place;
• protected against poor weather
conditions, at a recommended
temperature of between 0 and +40 °C.
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used
for maintenance are removed.
ATTENTION
Make sure that the battery is fully charged at
least once a month and always before use.
When re-starting the machine, set it up as
indicated in chapter "7. "Using the machine" .
11. HANDLING AND TRANSPORT
• When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting means assembly
to the highest position;
3. switch off the machine and
remove the ignition key
4. disengage the drive (par.6.3).
• When transporting the machine
on a vehicle or trailer, always:
• use an access ramp of suitable
strength, width and length;
• load the machine with the electric motor
switched off, with the key removed from
the ignition, without a driver and pushed
by an adequate number of people;
• lower the cutting -device assembly;
• position it so that it does not
cause a hazard to anyone;
• engage the drive (par.6.3).
• lock it firmly on the means of transport
using ropes or chains to prevent it from
tipping over and possible damage.
EN - 30