HP Compaq d530 USDT Hardware Reference Manual page 19

✎
✎
Hardware Reference Guide
3. To remove a module, press out on both latches 1 of the DIMM
socket at the same time. This releases the module and partially
pushes it out of the socket.
4. Lift the module from the socket.
If only one memory module is used in the system, it must be installed
in the same socket that held the preinstalled memory module.
5. To install a memory module, press out on both latches 1 of the
DIMM socket at the same time. Match the notch on the module
with the tab on the memory socket. Firmly push the module
straight into the socket 2, ensuring that the module is fully
inserted and properly seated. The latches will close automatically
when the module is seated correctly, securing the module in the
slot 3.
Adding or Removing Memory Modules
6. Replace the top access panel.
When the computer starts up, it will recognize the system memory
upgrade and automatically reconfigure the system.
www.hp.com
Hardware Upgrades
2–7