Replacing The Power Supply Unit - HP Brio BA300 Upgrade Manual

Hp brio ba300: supplementary guide

Hide thumbs Also See for Brio BA300:

Table of Contents

Upgrading and Replacing PC Hardware

Replacing the Power Supply Unit

WARNING

Hewlett-Packard does not support power supply upgrades. This information is provided to help you replace a defective

power supply unit. For your safety, only replace with a power supply provided by HP support services.

To avoid electrical shock, do not open the power supply. There are no user-serviceable parts inside.

1 Switch off the PC, disconnect the power cord and remove the PC's cover (refer to page 9).

2 Remove the three screws from the rear of the PC.

3 Disconnect all power cables from installed drives and from the system board.

4 Lift the power supply unit out of the PC.

5 Place the new power supply unit inside the PC and tighten the three screws on the rear of the PC.

6 Reconnect all the power cables to the drives and the system board.

7 Replace the cover (refer to page 11).

8 Check that the voltage switch is set correctly for your country (the voltage is set during manufacturing

and should already be correct).

Table of Contents