Safety And Installation; English - Cole Parmer FSB-200 Series Instruction Manual

Please read all the information in this Instruction Manual before using the unit.
WARNING
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite
combustible material.
Antylia Scientific Ltd have taken great care in the design of these units to protect operators from
hazards, but operators should pay attention to the following points:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS AND SAFETY GLASSES TO
PROTECT EYES.
• DO NOT use combustible substances near hot objects.
• DO NOT operate the instrument in the vicinity of inflammable liquids or gases.
• DO NOT place any liquid directly into the instrument.
• At all times USE COMMON SENSE.
OPERATOR SAFETY
All operators of Cole-Parmer equipment must have available the relevant literature needed to ensure their
safety. It is important that only suitably trained personnel operate this equipment in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment
is used in a manner not specified by Antylia the protection provided by the equipment to the operator may
be impaired.
All Cole-Parmer units have been designed to conform to international safety requirements and are fitted
with an over-temperature cut-out. On some models, the cut-out is adjustable and should be set to
suit the application. On all other models the cut-out is pre-set to protect the unit.
If a safety problem should be encountered, switch off at the mains power supply.
INSTALLATION
Before connecting the instrument to the mains electricity supply, check the voltage against the
rating plate (located on the back of the unit). Please note that the unit must be earthed to
ensure proper electrical safety.
Connections
Live
Neutral
Earth
Note: The FSB-200-5I and FSB-200-12I are classified as "Permanently Connected Equipment" and
should be connected to the electricity supply by a qualified electrician.
A suitable supply for the FSB-200-5I is rated at 4kW, 220-240V, 50/60Hz~ single phase.
A suitable supply for the FSB-200-12I is rated at 6kW, 220-240V, 50/60Hz~ single phase
The equipment is supplied with 2.5m of flexible, triple core, circular cable to the following specification:
4.0mm², to BS 6500 or equivalent and <HAR> or BASEC approved. Connection to the mains electrical
supply should be via a double pole 30mA Residual Current Breaker with Overcurrent protection (RCBO)
isolating circuit breaker switch with a continuous current carrying capacity of 30A at 250V and overcurrent
of 30A.
Do not switch on until the unit is fully installed.

SAFETY AND INSTALLATION

220V-240V
Brown
Blue
Green/yellow
6