HP Brio 8300 Online Manual page 57

Storage Device Cables Your computer has the following cables which may be used by storage devices:
•
A primary
which is already connected to the Master connector on this cable.
•
A secondary IDE drive cable with two connectors. If you already have a
Master connector on this cable. If you install a CD-ROM drive, or a third hard disk drive, or both, connect it or them to
this cable.
•
A floppy disk drive cable. This supports up to two floppy disk drives (or one floppy disk drive and one tape drive). One
3.5-inch floppy disk (Drive A) is already connected to the Master connector on this cable.
System Board If you add a floppy disk drive, hard disk drive, CD-ROM drive, Zip drive, or tape drive, you need to connect it to power
Connectors and data cables. The connectors are shaped to fit one way only. The data cables are shown below.
System Board
IDE hard disk drive cable with two connectors. This cable supports up to two IDE hard disk drives, one of
CD-ROM HDD FDD
Secondary IDE Connector
Primary IDE Connector
Floppy Disk Connector
CD-ROM drive installed, it is connected to the
FDD Master (Drive A)
FDD Slave
Connectors for 3.5-inch Floppy
Disk Drives or Tape Drives
3 Upgrading and Adding Accessories
Adding Accessories
Connectors for Primary
IDE devices
Primary Master
Primary Slave
Secondary Slave
Connectors for Secondary
IDE devices (CD-ROM
Drives, Zip Drives, or
IDE Hard Disk Drives)
Secondary Master
57