Table of Contents
Advertisement
How to Install the Washing Machine
Connecting the
water supply
26
3WPL090151.indd 26
3WPL090151.indd 26
Water supply hose
●
■
Optimum water pressure is 0.03-0.8MPa.
■
Do not connect to the mixer tap of an unpressurised hot-water
apparatus.
■
Use a horizontal tap.
Horizontal tap
Connect the water supply hose to the rear panel of
the washing machine.
Make sure that the rubber seal is inside the hose
connector.
* Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and
check connection points for water-tightness.
min. 10 mm
* Model with ONE TOUCH JOINT water supply hose.
1. Untighten the upper connector
screw.
Upper connector
Rubber packing
Fixing screw
●
In case the diameter of the tap
is large, remove the guide plate.
Guide plate
Connector
3. Connect the water supply
hose to the middle connector,
pushing the plate down.
Middle connector
Water supply hose
Extension tap
Hose connector
2. Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
tighten the 4 screws.
Rubber packing
Middle
connector
Upper connector
Middle connector
●
Turn the middle connector so
that there is no water leak.
●
To separate the water
supply hose from the middle
connector, turn off the tap, and
then pull the inlet hose down,
pushing the plate down.
Square tap
Rubber seal
3/3/2014 3:27:44 PM
3/3/2014 3:27:44 PM
Advertisement
Table of Contents
