Table of Contents
Advertisement
Problem
●
Foam remains
●
on the door or
the door seal.
●
Fabric softener
overfl ows.
●
Fabric softener
remains.
●
There's
detergent
●
powder residue
in the detergent
dispenser.
●
The washing
machine
switches off
during operation.
●
●
Odor in the
washing
●
machine
●
Unsatisfactory
washing results
●
●
Unusual noise or
vibration
●
●
●
Noise during
drain cycle
●
There's the
sound of water
when the drum is
rotated manually.
●
Tapping noise
comes out at
spin start.
●
Detergent
dispenser is wet.
●
Water remains in
washing machine
before initial use.
22
3WPL090151.indd 22
3WPL090151.indd 22
Troubleshooting
Possible Cause
You may have used too much detergent.
Laundry is new or not that soiled.
You may have exceeded the max. level of
softener in the detergent dispenser
The softener cover may have come out.
You may have used too much detergent.
You may have poured detergent in the
detergent dispenser when it was wet. Wipe
the water away before adding detergent.
There may be noise from other electrical
appliances nearby such as a TV, a radio,
etc.
The motor may be locked due to overload,
the clothes being trapped in the rubber seal,
etc.
Rubber parts may give off a smell when you
fi rst start using the washing machine.
There may be mold, dirt or detergent
residue on the drum.
You may have used too little detergent.
You may have poured detergent directly into
the drum.
The transport bolts may not have been
removed.
The washing machine may be installed on a
sloping or unstable surface.
There may be foreign objects inside the
drum.
This is normal. There may be noise when
the drain pump is on.
This is normal. Liquid is inside the 4-Ply
Liquid Load Balancer fi xed onto the drum to
make it balanced.
This is normal. Tapping sound is generated
when laundry touches to the laundry
protection bulge on the laundry inlet.
In some environmental or usage conditions,
Detergent dispenser may get wet due to
condensation.
There may be drops of water or
condensation in the washing machine due
to the factory inspection prior to shipment.
Solution
●
Use the appropriate amount of
detergent.
●
Do not pour in more than the
.
max. level of softener.
●
Firmly set the softener cover
on the detergent dispenser.
●
Use the appropriate amount of
detergent.
●
Wipe the water away before
adding detergent.
●
Unplug the power cord and
plug in again. Then select
a program and start. Do not
place electrical appliances
close to the washing machine.
●
This is not a malfunction. Wait
for about one hour and restart
the program.
●
The smell goes away over
time.
●
Run the Tub Clean program.
●
Use the appropriate amount of
detergent.
●
Pour detergent in the
appropriate dispenser.
●
Remove the transport bolts
before using.
●
Install the washing machine on
a horizontal, stable surface.
●
Remove foreign objects such as
coins, pins, etc. from the drum.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
3/3/2014 3:27:44 PM
3/3/2014 3:27:44 PM
Advertisement
Table of Contents
