Table of Contents
Advertisement
40
C
3: S
HAPTER
ETTING
Setting Up
Overview
U
M
P FOR
ANAGEMENT
This section gives an overview of what you need to do to get your Switch
set up and ready for management when it is in its default state. The
whole setup process is summarized in Figure 14. Detailed procedural
steps are contained in the sections that follow. In brief, you need to:
Configure IP information manually for your Switch or view the
■
automatically configured IP information
Prepare for your chosen method of management
■
Figure 14 Initial Switch Setup and Management Flow Diagram
How do you want to connect to the Switch?
Connect to the con-
sole port and use the
Command Line Inter-
face.
See page 43
Command Line Interface
Connect via the
console port.
See page 52
Power Up the Switch.
IP Information is automatically configured via
DHCP
See page 41
Do you want to manually
Yes
configure the IP information?
Connect to a front panel port
and use the Web Interface or
Command Line
Interface.
See page 43
How do you want to manage your Switch? See page 38
SNMP
See page 55
Connect over the
network via Telnet.
See page 52
No
How do you want to view the automatically
configured IP information?
Use 3Com Network
Connect to the console
Director (3ND).
port and use the
See page 50
Command Line
Interface.
See page 50
Web Interface
Connect over the
network.
See page 55
Advertisement
Table of Contents
