Cobalt Digital Inc 9902-2UDX-DI Product Manual page 105

Operating Instructions
.
Electronic device or assembly is susceptible
to damage from an ESD event. Handle only
using appropriate ESD prevention practices.
From underside of card, locate
1
the SD card receptacle
With SD card labeling facing up
2
(as shown), gently push the
card into the receptacle until it
clicks and locks into place
Press and hold MMC BOOT button
1
Power-up card and continue holding
2
button for 3 seconds, then release
button
9902-2UDXDI-OM (V1.0)
Figure 3-10 SD Card Installation
(See Figure 3-11.) With card powered-down, locate the
2.
button on the card. Proceed as shown in picture.
COM LED
Figure 3-11 MMC Boot Button
With button now released, the card will begin reprogramming:
3.
COM
•
When reprogram is complete,
•
again (entire process takes about 1-1/2 minute).
9902-2UDX-DI PRODUCT MANUAL
FRONT OF CARD
LED illuminates and remains illuminated.
Troubleshooting
MMC BOOT
COM LED turns off, on, and then off
3-71