Agp Slot; Connectors, Headers; Connectors - JETWAY 865GDMC User Manual

M/b for socket 478 pentium 4 processor
Table of Contents

Advertisement

IMPORTANT!
Example 1:
SiS 305 & ATi Rage 128 Pro AGP card those golden finger is compatible with
2X/4X mode AGP slot, but only can support 2X (3.3V) only. If you install these
cards in Intel® 865 based motherboard it will burn and damage the motherboard.
Example 2:
We also find Diamond Vipper V770 golden finger is design for 2X/4X mode AGP
Slot. It can be adjusted the jumper for AGP 2X (3.3V) or AGP 4X (1.5V). But the
factory default setting is 2X (3.3V). If you install this AGP card in motherboard
without change the jumper setting to 4X (1.5V), it will burn the motherboard.

2-6 Connectors, Headers

2-6-1 Connectors

(1)
Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes with
ATX case. The ATX Power Supply allows to use soft power on momentary switch that connect
from the front panel switch to 2-pins Power On jumper pole on the motherboard. When the
power switch on the back of the ATX power supply turned on, the full power will not come into
the system board until the front panel switch is momentarily pressed. Press this switch again
will turn off the power to the system board.
(2)
ATX 12V Power Connector (4-pin block) : ATX12V1
This is a new defined 4-pins connector that usually comes with ATX Power Supply. The ATX
Power Supply which fully support Pentium 4 processor must including this connector for
support extra 12V voltage to maintain system power consumption. Without this connector might
cause system unstable because the power supply can not provide sufficient current for system.
Before you plug-in AGP card, please make sure the following notice is fully
understood and practiced. If your AGP card has "AGP 4X notch (show
below) please make sure your AGP card is AGP 4X/8X (1.5V/0.8V) not AGP
2X (3.3V)
2x notch
Pin 1
PIN
ROW2
1
3.3V
3.3V
2
-12V
3.3V
3
GND
GND
4
Soft Power On
5V
5
GND
GND
6
GND
5V
7
GND
GND
8
-5V
Power OK
9
+5V
+5V (for Soft Logic)
10
+5V
+12V
11
4x notch
AG P SLO T
ROW1

Advertisement

Table of Contents
loading

This manual is also suitable for:

865gdmcp865pedmc865pedmcp

Table of Contents