Subscribe to Our Youtube Channel
Related Manuals for KYORITSU KEW MATE 2012RA
Summary of Contents for KYORITSU KEW MATE 2012RA
- Page 1 DIGITAL MULTIMETER WITH AC/DC CLAMP SENSOR KEW MATE 2012RA 1.800.561.8187 information@itm.com www. .com...
-
Page 2: Safety Warnings
This instrument satisfies the marking requirement defined 1．SAFETY WARNINGS in the WEEE Directive. This symbol indicates separate This instrument has been designed and tested according to collection for electrical and electronic equipment. IEC Publication 61010: Safety Requirements for Electronic This marking means they shall be sorted out and collected Measuring Apparatus. - Page 3 ● Do not install substitute parts or make any modification to ●True-RMS measurements ACV and ACA. the instrument. Return the instrument to Kyoritsu or your ●Auto-power-save function distributor for repair or re-calibration.
-
Page 4: Specifications
3．SPECIFICATIONS Resistance Ω (Auto-range) Range Display range Allowable input Accuracy ● Measuring Ranges and Accuracy (at 23 ℃ ±5 ℃ , relative humidity75% or less) 600Ω 0.0～603.9Ω AC Current A (RMS value detection) Maximum Input Current : 120A 6kΩ 0.560～6.039kΩ ±1.0%rdg±5dgt Range Display range... - Page 5 Frequency Hz ( AC Current ) (Auto-range) ●Safety Standard IEC 61010-1, 61010-2-032, 61010-2-033 CAT III 300V, pollution degree 2 Range Display range Allowable input Accuracy CAT II 600V, pollution degree 2 IEC 61010-031 10Hz 0.000～9.999Hz The accuracy is not guaranteed EN 61326-1 (EMC) 100Hz 9.00～99.99Hz...
-
Page 6: Instrument Layout
Test Lead Cap：Test leads can be used under the CAT.II and III 4．INSTRUMENT LAYOUT environments by attaching a Protective cap as illustrated below. Use of our Protective cap offers different lengths Holster suitable for the test environments. Clamp Sensor Test Lead Exposed metal part Protective Cap LCD Display... - Page 7 Note:◇ The direction of current is plus(+) when the current Note:◇ Make sure that the clamp sensor is in the holster while 6．HOW TO MAKE MEASUREMENT flows from the upside (A ZERO ADJ. Button side) to the making voltage measurement. underside The direction is minus(-) when the current flows ...
- Page 8 6-4 Diode Measurement 6-7 Frequency Measurement (1) Set the Function Selector Switch to " ". # DANGER (2) Press the Button. "" mark is shown on the display. ● In order to avoid possible shock hazard, never make (3) Connect the test leads to the circuit under test. measurement on circuits with a maximum voltage difference The measured value appears on the display.
-
Page 9: Other Functions
7-2 Data Hold Function [ How to storage the clamp sensor and the test leads ] 7．OTHER FUNCTIONS This is a function to freeze a measured value on the display. Clamp Sensor Press the Button once to hold the current reading. In this 7-1 Auto-Power-Save Function data hold state, the reading is held even if input varies.
Need help?
Do you have a question about the KEW MATE 2012RA and is the answer not in the manual?
Questions and answers