Filling The Rinse Aid Reservoir - Hisense HS620D10WUK Instruction Manual

Filling The Rinse Aid Reservoir

1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. S witch on the appliance
2. Within 60 seconds after step 1, press the Program button more than 5 seconds,
then press the half
indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits ,
the sets will change in the following sequence: D3->D4->D5->D1->D2->D3.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the power button to exit the set model,
the set success.
Rinse aid level
.
-
load button once to enter the set model, the rinse aid
D1
D2
D3
D4
D5
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
Selector position
Soak Light bright
Quick Light bright
Quick, Soak Light bright
Eco Light bright
Eco, Soak Light bright
11