Table of Contents
Advertisement
For chisel blade
Optional accessory
Align the protrusion on the gear case with the groove on
the protector, and then attach the protector to the clamp
using bolts.
2
► 1 . Clamp 2. Protector 3. Protrusion 4. Groove
For shredder blade
Optional accessory
Attach the protector to the clamp using bolts.
2
► 1 . Clamp 2. Protector
Installing the cutting tool
CAUTION:
Always use the supplied wrenches
to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the gear case after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Cutter blade / chisel blade / shredder
blade
CAUTION:
always wear gloves and put the blade cover on
the blade.
CAUTION:
ished, and free of cracks or breakage. If the cutter
1
blade hits a stone during operation, stop the tool and
check the cutter blade immediately.
CAUTION:
blade must be as follows. Never use any cutter
blade with larger outside diameter.
—
—
3
—
4
—
—
—
1
► 1 . Nut 2. Clamp washer 3. Cutter blade 4. Spindle
5. Receive washer 6. Hex wrench
1.
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
so that the arrows on the cutter blade and protector are
pointing in the same direction.
► 1 . Arrow
16 ENGLISH
When handling a cutter blade,
The cutter blade must be well pol-
The outside diameter of the cutter
2-tooth blade : 305 mm
3-tooth blade : 305 mm
4-tooth blade : 255 mm
8-tooth blade : 255 mm
Chisel blade : 225 mm
Shredder blade : 270 mm
4
5
Insert the hex wrench through the hole in the gear
Mount the cutter blade onto the receive washer
1
1
2
3
6
1
Advertisement
Table of Contents
