Dometic HiPro Alpha A30P1 Operating Manual page 18

Troubleshooting
Fault
Poor cooling perfor-
mance
Frost formation in the
minibar compartment
Interior lighting not
working
18
Possible cause
Cooling unit not sufficiently ventilated Provide sufficient ventila-
Minibar exposed to direct sunlight
Door of minibar not closed with a
tight seal
Minibar recently filled
For versions with absorber cool-
ing: The input voltage is too low or
high.
Door of minibar not closed with a
tight seal
Power plug not plugged in
Interior lighting is defective
Surface of infrared door sensor is cov-
ered by condensate water
HiPro
Solution
tion, see Installation
Manual
Take minibar out of direct
sunlight
Check distances, see
Installation Manual
Contact service agent.
Service agent: Replace
door seal
Check cooling again after
5 to 6 hours
Check input voltage
Check distances, see
Installation Manual
Contact service agent.
Service agent: Replace
door seal
Insert power plug into
socket
Contact service agent.
Service agent: Change
interior lighting
Clean the surface of the
infrared door sensor
EN