Table of Contents
Advertisement
Suggested machine installations
The dishwasher can be installed built-in, completely freestanding
or partially built-in.
A. Built-in
The dishwasher is intended for installation under a worktop. The
recess dimensions are illustrated. Holes for wires/cables need
not be larger than 38 mm in diameter. Make sure the edges of
such holes are even to prevent damage to the drainage and inlet
hoses and the power cable.
[mm]
*Remove locking nuts for an installed height
of 820-821 mm.
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets.
This comprises two brackets, which are screwed into place as
illustrated.
The dishwasher is then pushed in so that the brackets engage
the rear feet. Now the dishwasher will not topple if pressure is
put on the open door. If the dishwasher is installed completely
on its own, side panels and a worktop must both be fitted. Acces-
sories can be purchased where you bought the dishwasher.
WARNING!
A completely freestanding dishwasher must be fitted with anti-
tip brackets.
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a
side panel must be fitted. Accessories can be purchased where
you bought the dishwasher.
560
Adjust the height and slide the
dishwasher into place
1 Start by measuring the height from the floor to the bottom
edge of the worktop.
2 Measure the height from the floor to the top edge of the dish-
washer.
3 Adjust all feet by turning them clockwise to raise or anticlock-
wise to lower the dishwasher.
24 mm
4 Check that there is an air gap of at least 3 mm between the
underside of the worktop and the top edge of the dishwasher.
5 Tighten the lock nuts (lock nut) on the rear feet.
6 Slide the dishwasher into place.
Pull through the drainage and supply hoses when the ma-
chine is slid into place.
Check that the hoses have no kinks or sharp bends, and
check that there is nothing that can damage the hoses.
7 Make any final adjustments to the front feet (the dishwasher
may lean no more than 5 mm) and tighten the lock nuts.
If you want to install your dishwasher freestanding, skip steps 1,
2 and 4 above.
Drainage connection
When the drainage hose is routed to a connection nipple on the
sink unit's water trap (see illustration 1), please note that the hose
must be attached at the same height as the underside of the sink
unit, otherwise dishwater from the sink may flow back into the
dishwasher. The drainage hose is threaded onto the cone-shaped
connection pipe on the sink unit's water trap. The cone-shaped
pipe must be cut to an internal diameter of at least 14 mm. For
other connection alternatives, see illustrations 2 and 3.
The drainage hose may be extended by a maximum of 3 m (the
total length of the drainage hose must not exceed 4.5 m). Any
joins and connecting pipes must have an internal diameter of at
least 14 mm. However, the drainage hose should ideally be re-
placed with a new hose without joins.
19
Advertisement
Table of Contents
