Cabling The Server With Keyboard, Video, And Mouse - IBM S922L Installing

Table 4. Console settings and functions
Console Setting
E2
D1
Bn
Notes:
1) Use the earlier recorded slot number to determine which Bn function must be selected. For
example, if you are using the I/O adapter in slot C2, you can select console setting B2 to
configure the location of the adapter.
2) The Bn might advance from search order rather then numerically. For example, if the search
order is C4,C3,C1, the Bn numbers might display 4 before another lower number. This is
determined by the model, and not all models are affected.
3) If A60x500D is displayed, function has timed out because the function has been entered
slowly). You have a minute to complete a 65-21-11 sequence. After you start, select the
required settings with no pauses.
9. Restart the console. Use the 65+21+11 sequences until the console displays A6A3500B. This indicates
a console restart. The system searches for a console resource based upon the current configuration
(E1/E2, D1/D2, Bn) and the resource activates. Use the 21+11 sequences. If the console displays
A6A3500C, a console search and activate has been requested. If the console displays A6A3500C,
repeat function 11 until the console does display A603500C.
10. Connect the console by completing the following steps:
a. Monitor the console status. After the status changes to Pending Authorization, the Service Tools
Sign-On window opens.
Note: The Service Tools Sign-On window might open behind the Operations Console window.
Resize or move the Operations Console window to locate the Service Tools Sign-On window.
b. Sign on to the Service Tools application. To sign on to the Service Tools application, enter
11111111 for the user ID and password.
c. Load the initial program and configure the system.
d. If your session does not connect, wait for the power-on process to stop on an attention or IPL
failure system reference code (SRC), such as A6005008 or B2xxxx. If the power-on stops at
A6005008, call your IBM service provider for assistance.
Note: You must configure and start an IBM i TCP interface on a second port (T2, T3, T4) before
moving the console. This action ensures that there is an alternative method to access the server.
Reset the PC to its original TCP/IP settings.
Note: The PC IP configuration must be reset before cabling the PC back to the network because the
PC is configured with the gateway IP address.
The PC and server console port (T1) can now be recabled to the network.
Continue with "Completing the server setup" on page 18.

Cabling the server with keyboard, video, and mouse:

Before you start the system, you might need to connect the keyboard, video, and mouse to the system, if
a graphics card is present.
Function
Enable add-on adapter (OPSCONSOLE ENBEXTLAN)
Disable embedded port (OPSCONSOLE DISINTLAN)
Enable LAN adapter in slot Cn (OPSCONSOLE
ENBLSLOT n)
Note: This setting requires that the embedded (internal)
LAN flag is turned off and the external flag is turned on.
Otherwise, you will not see this series.
Installing the IBM Power System S922L (9008-22L)
17