Table of Contents
Advertisement
ADJUSTING CARBURETTOR
(As Required)
GENERAL INFORMATION
The idle speed adjuster screw controls the
throttle opening at the idle position.
IDLE ADJUSTMENT
1. Start engine and allow it to run at high idle
until warm.
2. Turn the idle speed screw clockwise until
drill begins to move.
3. Turn idle screw counter-clockwise 1-1/2
turn or until the drill stops (2,700 ~ 3,300
rev/min).
CLEANING CYLINDER FINS
(Check Periodically)
NOTE
Clogged fins will cause poor engine cooling.
1. Carefully remove housing and clean dirt and
dust from fins.
2. Reinstall housing.
CLEANING SILENCER AND
EXHAUST PORT (Check
Periodically)
1. Carefully remove housing halves.
2. Remove and disassemble silencer.
NOTE
Be careful not to scratch the cylinder or
piston when cleaning the cylinder exhaust
port.
3. Clean deposits from cylinder exhaust port
~
2
and silencer.
12
Advertisement
Table of Contents
