Throttle trigger
Air cleaner
Purge bulb
Push
Fuel return line
RUN
(Open)
START
(Close)
On
Stop
Choke lever
8
IMPORTANT
Stored fuel ages. Do not mix more fuel
than you expect to use in thirty (30) days,
ninety (90) days when a fuel stabilizer is
added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.
STARTING COLD ENGINE
•
Stand the engine upright on a level surface.
•
Slide ignition switch to "ON" position.
(START/RUN)
•
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
•
Shift choke shutter to close position.
(START)
•
Open throttle trigger to a fast idle.
•
Pull recoil starter until the engine fires.
•
Shift choke shutter to full open position,and
if necessary, start the engine again and
allow to warm up before using.
- The clutch engages at approximatery
3500 rpm. therfore the cutter may rotate at
fast idle engine speed.
STARTING WARM ENGINE
•
Ignition switch to "ON" position.
•
Pull starter handle until the engine fires.
- Do not use the choke.
STOPPING ENGINE
•
Set throttle trigger in idle position.
•
Slide ignition switch to "STOP" position.
NOTE
When engine does not stop, shift choke
shutter to close position.
Check and repair stop switch before starting
the engine again.