Table of Contents
Advertisement
2.3 WIRING
Review the Operation Section (4.0) in order to select the proper hook-up and use of the POWERPATH.
Set switches and wire the POWERPATH as follows: Terminal locations for the Power Supply/Battery Charger
PC board are shown in Figure 4. Terminal locations for the Control PC board are shown in Figure 6.
NOTE: The maximum current on a Class "A" or "B" output is 3 Amps with the rest of the NAC Extender
output current divided among the remaining circuits.
DO NOT CONNECT WIRING TO THE AC INPUT SOURCE OR TO THE BATTERIES UNTIL ALL WIRING
AND ALL SWITCH SETTINGS HAVE BEEN MADE
POWER LIMITED AND NON-POWER LIMITED WIRING SHALL BE SEPERATED AND SHALL NOT BE
WITHIN 1/4" OF EACH OTHER. NON POWER LIMITED WIRE SHALL BE SEPERATED FROM PC BOARDS
BY 1/4".
Power Supply/Battery Charger PC Board
NOTE: Sealed Lead Acid Batteries shall be used for backup batteries.
P84905-002 A
Sheet 9 of 37
firealarmresources.com
Advertisement
Table of Contents
Need help?
Do you have a question about the PS-8-LP and is the answer not in the manual?
Questions and answers