Advertisement
Quick Links
AP-90-MNT-W2
Installation Guide
Introduction
The AP-90 Series Wall Mounting kit provides two options, with built-in security features, for mounting your
AP-90 Series to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount
Bracket to install the AP directly on a wall.
The kit includes the following:
1x plastic Wall Mount Bracket
Figure 1 AP-90-MNT
Required Tools
A screwdriver that matches the screws used for mounting your brackets.
An M5 (Metric) or 3/16" (Standard) hex key.
0511183-01
| January 2013
Wall Mount Bracket
1
Advertisement
Related Manuals for Aruba Networks AP-90 Series
Summary of Contents for Aruba Networks AP-90 Series
- Page 1 The AP-90 Series Wall Mounting kit provides two options, with built-in security features, for mounting your AP-90 Series to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount Bracket to install the AP directly on a wall.
- Page 2 Installation 1. Before securing your mount a double-gang box or directly to the wall, route the ethernet cable through the openings show in Figure Figure 2 Cable Routing Wall Mount Bracket Cable Route to ENET Port 2. Install your mounting bracket. For the Wall Mount Bracket (Figure a.
- Page 3 3. Connect the ethernet cable to the ethernet port (ENET) on the back of the AP. 4. Secure the AP to the mounting bracket by aligning the mounting holes on the back the AP with the mounting post on the bracket. 5.
- Page 4 6. To remove the AP from the mounting bracket, begin by inserting an M5 or 3/16" hex key into the hole shown in Figure 7. Use the hex key to depress the tab on the AP and push the AP up, releasing the AP from the mounting post on the bracket.