Contents; Quick Start - NEC AccuSync AS224WMi User Manual

Contents

Your new NEC AccuSync LCD monitor box* should contain the following:
• AccuSync LCD monitor with tilt base
• Audio Cable
• Power Cord
• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)
• Setup Manual
• Base Stand
• Cable Holder
Setup Manual Audio Cable
* Remember to save your original box and packing material to transport or ship the monitor.
*1 Type of power cord included will depend on the where the LCD monitor is to be shipped.

Quick Start

To attach the Base Stand to the LCD Stand:
1. Attach the Base Stand to the Stand. The locking tabs on the Base Stand should fi t into
the hole on the Stand (Figure S.1).
To attach the AccuSync LCD monitor to your system, follow these instructions:
1. Turn off the power of your computer.
2. For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of
the display card in your system (Figure A.1).
For a PC or MAC with DVI digital output: Connect the DVI signal cable to the
connector of the display card in your system (Figure A.2). Tighten all screws.
For a PC with Analog output: Connect a 15-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.3).
For a MAC with Thunderbolt output: Connect a Mini DisplayPort to DisplayPort
adapter to the computer and then attach the DisplayPort cable to the adapter and to the
display (Figure A.4).
DisplayPort cable DVI cable (not included)
(not included)
Figure A.1
NOTE: 1. When removing the DisplayPort cable, hold down the top button to release the lock.
2. Please use a DisplayPort Certifi ed DisplayPort cable.
Power Cord* 1 Video Signal Cable
Figure A.2
English-6
Cable Holder
Base Stand AccuSync LCD monitor
(Base Stand not connected)
Stand
Figure S.1
Macintosh Cable Adapter Macintosh Cable Adapter
(not included) (not included)
Figure A.3
Base Stand
Figure A.4