Acer L811 EL8630Ua Series User Manual page 32

22
area network.
2. Open the web browser on your PC and type in the LAN IP of the projector.
(See the LAN IP in the Setting > LAN > LAN IP/ Mask menu.)
3. Set a password. Password needs to be at lest 8 characters in length and use
a mix of the following 3 types of letters: uppercase letters, lowercase letters
and digits. Enter the password a again to confirm it.
4. The remote network operation page displays and you can control the
projector. If not, perform LAN Reset in the Setting > LAN menu of the
projector's OSD menu and then try again.
Note 1 : An overview of the remote network operation page
To switch input
signals, click your
desired signal.
Note 2 : An overview of the Tools page
You can enter
the projector
information.
DHCP can be
disabled and
these settings
have to be
configured
manually.
Note 3: The Info page shows the projector information and status.
Mac Address
can be
obtained
from here.
See Note 2 and
Note 3.
These buttons
function the
same as those
on the OSD
menus,
projector
control panel,
or remote
control.
You can set the
user password/
administrator
password to
prevent
unauthorized use
of the remote
network
operation/Tools
page.