Connecting The Water Draining Hose To The Drain - Beko WTV 8744 XDW User Manual

6.5 Connecting the water draining hose to the drain

• Attach the end of the drain hose directly to waste water
drain, washbasin or bathtub.
• Do not contact the discharged water. Risk of being burnt as
the water may be hot.
CAUTION!
• Fix the water drain hose end completely to prevent risk of
dislocation.
EN / 20
a) Connect the water drain hose to a minimum height of 40 cm and a
maximum height of 100 cm.
b) The product may fail if water drain hose is at or close to floor level
(under 40 cm) as it would take water in and out continuously.
c) The product may fail if water drain hose is placed higher than 100 cm
as it cannot discharge water and water stays inside the product.
Therefore, follow the heights described in the figure.
d) To prevent the waste water to go back into the product again and to
ensure easy drainage, do not immerse the end of the hose into the
waste water or do not insert it into the drain for more than 15 cm. If it
is too long, cut it short.
e) The end of the hose should not be bent, it should not be stepped
on and the hose must not be pinched between the drain and the
product.
f) If the length of the hose is too short, use it by adding an original
extension hose. Total length of the hose may not be longer than 3.2
m. Otherwise, the product may fail as it would take water in and out
continuously.
Washing Machine / User's Manual