Cleaning The Loading Door; Cleaning The Body And Control Panel - Beko WTV 8744 XDW User Manual

13.2 Cleaning the loading door

13.3 Cleaning the body and control panel

EN / 58
g) Use a flat screwdriver to remove the tabs holding the upper cover of
the detergent drawer (there are 6 tabs in total: two on the right side
of the drawer, two on the left and two at the back) and wash the
inside of the drawer.
h) After washing it, place the cover back to its location. Make sure that
all tabs are fitted. If the tabs do not seat properly, liquids may leak
or the detergent drawer may get stuck or difficultly move on the
drawer slide. For this reason, please ensure that the tabs are fitted
in place.
i) Fit the discharge bar to its slot at the back of the drawer.
j) Paying attention to its slot and slides, fit the drawer back in place
and push it to close. After adding detergent and softener, it will be
ready to be used in programmes with dosing function.
a) After every washing make sure that no foreign substance is left in
the product.
b) If the holes on the bellow shown in the figure is blocked, open the
holes using a toothpick.
c) Foreign metal substances will cause rust stains in the drum. Clean
the stains on the drum surface by using cleaning agents for stainless
steel.
d) Never use steel wool or wire wool. These will damage the painted,
chromated and plastic surfaces.
a) Wipe the body of the product with soapy water or non-corrosive
mild gel detergents as necessary, and dry with a soft cloth.
b) Use only a soft and damp cloth to clean the control panel.
Washing Machine / User's Manual