Advertisement
Quick Links
INSTRUCTION MANUAL
AKIRA 240CM EXT. DINING TABLE
ITEM CODE: 18AKIT10
Imported by Furniture Solutions (Aust) Pty Ltd New South Wales, Australia.
For any assistance with assembly or for missing parts please contact:
Place of purchase or Furniture Solutions on below
Customer Service (Australia) Phone-1300 794 188
Email- customerservice@furnituresolutions.com.au
1
Advertisement
Related Manuals for Furniture Solutions AKIRA 18AKIT10
Summary of Contents for Furniture Solutions AKIRA 18AKIT10
- Page 1 INSTRUCTION MANUAL AKIRA 240CM EXT. DINING TABLE ITEM CODE: 18AKIT10 Imported by Furniture Solutions (Aust) Pty Ltd New South Wales, Australia. For any assistance with assembly or for missing parts please contact: Place of purchase or Furniture Solutions on below Customer Service (Australia) Phone-1300 794 188 Email- customerservice@furnituresolutions.com.au...
-
Page 2: Pre-Assembly Preparation
PRE-ASSEMBLY PREPARATION Before you start: Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product Take care when lifting. Product should be assembled as near as possible to the point of Ensure that you have all required contents for complete assembly Always read the assembly instructions carefully before beginning assembly. - Page 3 Table Top P.TP6358.T3.T x 1 Table Leg P.TP6358.T3.L x 4 ASSEMBLY INSTRUCTIONS Please prepare work area as instructed in page 2: To Attach Leg: Please note it will require two people to assemble and place table in position. Take table leg and aline thread hole in leg with hole in the corner of table as indicated in diagram below.
- Page 4 ASSEMBLY INSTRUCTIONS Please prepare work area as instructed in page 2: Once all 4 legs are attached, you need the help of extra person as you will need to lift the table into the air and rotate it in mid air. Once feet are level with ground lower table gently. Please do not roll table over on its side to stand up you may damage the fitting under the table.
- Page 5 OPERATION OF EXT. INSTRUCTIONS Please note that to extend table there are two (2) locks engaged at factory. They are located under the table past the slide action, you will need to get under table to locate the first time. As shown diagram it is a toggle black in colour to release pull down and to lock push up.
- Page 6 OPERATION OF EXT. INSTRUCTIONS Once table is fully extended move around to middle of table, you will see the ext. piece folded in half. Before you move ensure that ext. piece has enough gap to open up as to not touch the two (2) table top panels.
-
Page 7: Care And Maintenance
2/3 water using a soft non-metallic brush, please rinse thoroughly with clean water and dry as above. Some scratchers and marks can be sanded out depending on surface of Polywood please contact Furniture Solutions before attempting to repair. Definition of Regular Cleaning;... -
Page 8: Safety Warnings And Advice
SAFETY WARNINGS AND ADVICE Notices and Advice Please be advised that products are limited in design for residential use only and are not suitable for commercial use. Please be advised that materials used in your furniture are not impervious to neglect, acts of god, abuse, alcohol spills, improper use of chemicals such as bleach or any solvent based products. - Page 9 To make a warranty claim, customers can either contact the retailer where the purchase was made or Furniture Solutions on contact details below. Proof of purchase will be required before proceeding with any claim. In the case of product defects providing photos may be able to speed up processing of the claim.