Table of Contents
Advertisement
Fault Codes
1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
2.If the display reads "EC" , check the following operating conditions. Outlet voltage should be 115V±10% and the
surrounding temperature should be with in the range of 41 °F to 89 °F. Unplug the unit and plug it in again under
normal operating conditions. If the "EC" code persists, contact your Authorized Frigidaire Service Center.
3.If the display reads "E4", the communication between display PCB and main control PCB is faulty. Contact your
Authorized Frigidaire Service Center.
Removing Collected Water
1. Emptying the Bucket:
a. When the
bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
WARNING
Discard water from bucket. Water is not potable and cannot be used for drinking.
2019 Electrolux Home Products, Inc.
Operating Instructions
All rights reserved.
9
Advertisement
Table of Contents
