Table of Contents
Advertisement
Operating Instructions
(continued)
4. To use Dry mode, press the Mode button to choos Dry mode. In this mode, you can press the HUMIDITY - or + buttons
to choose a value between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the - or + buttons will
change the humidity selection in 5% increments. 5 seconds after you have set the desired humidity, the readout will display
the actual room humidity.
5. During the Dry mode, You can also use the FAN SPEED button to change the fan speed to Hi, Med or Lo. The indicator
light will show the setting you have selected. A higher fan speed will result in quicker moisture removal.
6. To use CONTINUOUS mode, when in Dry mode pressing the " - " button until the display reads CO. In this mode, the
unit will continuously on and the unit will only display CO not the room humidity. To leave this mode, press the " + "
button.
7. The Filter reset light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section
to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the Filter reset button
to extinguish the light.
2019 Electrolux Home Products, Inc.
Operating Instructions
All rights reserved.
7
Advertisement
Table of Contents
