Washing The Dishes; Aqua Sensor; Switching On The Appliance; Optical Display While The Programme Is Running - Bosch SBV69T00AU/44 Operating Instructions Manual

Table of Contents

Advertisement

aus

Washing the dishes

A qua sensor *
Aq u a s e n s o r
* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.

Switching on the appliance

– Turn on the tap fully.
– Open the door.
– Switch on ON/OFF switch (.
The display of the last selected
programme flashes. This programme
remains selected if no other
programme button 0 is pressed. The
expected programme duration flashes
on the digital display 8.
– Press the START button h.
– Close the door.
The programme starts running.
14
Optical display while the
Op t i c a l d i s p l a y wh i l e t h e pr o g r a m me i s r u n n i n g
programme is running *
* depending on model
While the programme is running, a light
spot shines on the floor under the
appliance door. Do not open the
dishwasher door until the light point is no
longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point is
not visible.
This function can be changed as follows:
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button h until : .... is
indicated on the digital display.
– Release both buttons.
– Press programme button # until the
factory set value :
the digital display 8.
To change the setting:
– By pressing the button 3, you can
switch the function off :
:
.
– Press START button h.
The set value is saved.
– Close the door.

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display 8.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
is indicated on
or on

Advertisement

Table of Contents
loading

Table of Contents