Table of Contents
Advertisement
Additional options
* depending on model
Additional options can be set with the
buttons @.
Ÿ
Express Wash/ Speed
Perfect *
The >>Express Wash/ Speed Perfect<<
function can reduce the running time by
approx. 20% to 50% depending on the
selected rinse programme. The change in
the running time is indicated on the digital
display `. To obtain optimum cleaning
results at a reduced running time, water
and energy consumption are increased.
§
Half load *
If you have only a few items to wash (e.g.
glasses, cups, plates), you can switch to
"half load". This will save water, energy
and time. It is recommended to put a little
less detergent in the detergent dispenser
than for a full load.
–
Timer programming *
You can delay
the start of the programme in 1 hour steps
up to 19 hours.
– Switch on the main switch (.
– Press the timer programming button
until the digital display ` jumps
to
.
– Keep pressing the timer programming
button until the required time
is displayed.
– To delete the preselected starting time,
press the button until
is indicated on the digital display `.
You can change your programme
selection at any time until
the programme starts.
Washing the dishes
Programme data
The programme data (consumption
values) can be found in the summary
of instructions. They refer to normal
conditions and the water hardness set
value . Different influencing factors such
as water temperature or line pressure may
result in deviations.
Aqua sensor *
* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 2–4 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.
Switching on the appliance
– Turn on the tap fully.
– Close the door.
– Rotate programme selector 8
to the required programme.
– Switch on the main switch (.
The expected programme duration
is indicated on the numerical
display `.
– The programme starts running.
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display `.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
en
15
Advertisement
Table of Contents
