Washing The Dishes; Aqua Sensor; Switching On The Appliance; Remaining Running Time Display - Bosch SMU68M05AU Instructions For Use Manual

aus

Washing the dishes

Aqua sensor *

* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted
to the degree of soiling.

Switching on the appliance

Turn on the tap fully.
Close the door.
Switch on ON/OFF switch
The display of the last selected
programme flashes. This programme
remains selected if no other programme
button is pressed.
2
The expected programme duration
flashes on the digital display
Press the START button
The programme starts running.

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
14

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.

End of programme

.
1
The programme has ended when the
value
display

Switching off the appliance

.
Short time after the end of the programme:
9
.
6
.
9
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Close the door.
Switch on ON/OFF switch
Press + button until the digital
4
display jumps to
9
Press + or – button until the
4
displayed time corresponds with
your requirements.
Press START button
programming is activated.
To delete timer programming, press
the + or – button until
4
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
is indicated on the numerical
.
9
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they
have cooled down.
Warning
.
1
.
, timer
6
.
1