Download Print this page

Section 6: Regulatory Information - Elo Touch Solutions ECMG4 User Manual

Interactive digital signage for ids xxx3l

Advertisement

Section 6: Regulatory Information

Electrical Safety Information
Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer's label. Connection to a different
power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not
followed.
There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this equipment which constitute a safety
hazard. Service should be provided only by a qualified service technician.
Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment to mains power.
Emissions and Immunity Information
Notice to Users in the United States:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Notice to Users in Canada:
This equipment complies with the Class A limits for radio noise emissions from digital
apparatus as established by the Radio Interference Regulations of Industrial Canada.
CAN ICES3(A)/NMB3(A)
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
User Manual – Elo Computer Module
UM600337 Rev. C, page 21 of 31

Advertisement

loading