Notes And Cautions - Samsung POWERbot VR A72 Series User Manual

Notes and cautions

Charging
Note
f If the battery overheats during charging,
it may take longer to charge.
f When automatic charging is not working,
do the following:
– Turn the emergency switch (on the bottom
of POWERbot) off and on again.
– Unplug the docking station's power plug
and then plug it back on.
– Unplug the docking station, and then check
whether there is any foreign matter on the
charge pins and clean POWERbot and the
charge pins of the docking station with a
dry cloth or rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the docking station.
f If POWERbot is left detached from the
docking station, the battery will drain
naturally.
– Try to keep POWERbot being charged on
the docking station. (However, turn off the
emergency switch and leave the docking
station unplugged when planning to leave
the house for long periods of time by going
on a business trip or vacation, etc.)
Using
Note
f The POWERbot may get caught on
thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move the POWERbot to an area
where it can move easily, and then turn on
the power again.
f The POWERbot cannot completely clean
areas it cannot enter, such as corners,
between the wall and sofa, etc.
– Please use another cleaning tool to clean
them regularly.
1_VR7200_EN_DJ68-00827B-03_AA.indd 28
f The POWERbot cannot vacuum clumps
of dirt, so some may remain on the floor
after cleaning.
– Please use another cleaning tool to clean
them regularly.
f If POWERbot is turned off, you cannot
turn it on by pressing the Power button
on the remote controller. Press and hold
the [Start/Stop] button on POWERbot.
f You cannot select and have the POWERbot
execute Spot clean mode while it is
charging.
f If you press Manual clean / Point cleaning
button while charging, the POWERbot will
be detached from the docking station and
then turn into the standby mode.
Cleaning and maintenance
Note
f If you washed the dustbin and filter with
water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in the shade before
using.
f When cleaning the auto shutter tool, do
not pull the auto shutter tool out too hard.
Caution
f Watch your fingers when attaching or
detaching the filter, since they may get
stuck in the dustbin's intake.
f To avoid blockages by foreign matter,
do not let the POWERbot vacuum up
toothpicks, cotton swabs etc.
f If it is difficult to remove foreign matter
from the brush, contact an authorized
Samsung service center.
ENGLISH-28
2020-01-13 오전 1:13:30