Perlick HH24 Installation Manual page 10

PERLICK RESIDENTIAL INSTALLATION MANUAL
7). Remove the front panel from the door assembly by
removing the inner mounting screws, 4 per side, from the
perimeter of the door assembly (Fig. 11). Rotate the front
panel 180°. The top becomes the bottom. Reattach using
the same screws and mounting holes.
Front panel
Corner screws need not be
removed to remove front panel
Figure 11. Removing Front Panel
8). Remove the Perlick nameplate from the door front
using a plastic putty knife (Fig. 12). Install the new Perlick
nameplate included in the kit.
Nameplate
Figure 12. Nameplate
10 perlick.com
9). Insert the bearing into the door hinge bracket (Fig. 13).
10). Insert the V-block into the door bottom hinge bracket
and attach with the e-clip (Fig. 13). Note the orientation of
the V-block.
Bearing in
door top hinge
bracket
Door bottom bracket
Orientation
Figure 13. Bearing and V-Block
11). Attach the top and bottom hinges and push plunger
using screws removed in step 6 (Fig. 14).
Top hinge
and screws
Bottom hinge
and screws
Figure 14. Door Hinges
6°
V-block
BOTTOM VIEW