How To Connect The Pc Input Terminals - Panasonic TH-42PW3 Operating Instructions Manual

Connections

How to connect the PC Input Terminals

COMPUTER
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed
properly.)
(2) The display resolution is a maximum 640
when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible
to show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible,
you will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(6) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(7) The computer shown in the illustration is for example purposes only.
(8) Additional equipment and cables shown are not supplied with this set.
(9) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the
specified frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input
Terminal
14
Conversion adapter (if necessary)
Audio
Connect a cable which matches
the audio output terminal on the computer.
480 dots when the aspect mode is set to "4:3", and 852
Pin No. Signal Name
1 R
2 G
3 B
4 GND (Ground)
5 GND (Ground)
POWER / R - STANDBY INPUT — VOL +
G POWER ON
RGB
PC cable
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
AUDIO
PC IN
D-sub 15p
1/8" (3mm) Stereo Plug
480 dots
Pin No. Signal Name
11 GND (Ground)
12 SDA
13 HD/SYNC
14 VD
15 SCL