Electrical Connection - Bosch DHU635PGB Installation Instructions Operating And Installation Instructions

Before installation
Exhaust air towards the rear:
Pipe diameter: 100 mm
Break off cover on the rear panel of the
extractor hood; strike the retaining
points with a tool.
To prevent damage to the fan, hold the
tool vertically.
Remove the broken off metal part
(possibly a noisy and disruptive
procedure).
If the extractor hood has 2 motors, the
opening on the plastic part must be
made at the rear; cut through the 3 ribs
and remove the cut-off part.
Cut off the outer part of the exhaust-air
connection.
Insert the inner part and turn as far as
possible.
Circulating-air mode
With activated carbon filter if exhaust-air
mode is not possible.
The air purified by an additional
activated carbon filter is conveyed back
into the room.
For insertion of the activated carbon
filter see Instructions for use.
If the extractor hood is switched from
exhaust-air mode to circulating-air
mode, the exhaust-air opening must be
sealed to prevent a hazardous situation
(see optional accessories in the
Instructions for use).

Electrical connection

WARNING: THIS APPLIANCE MUST BE
EARTHED
IMPORTANT: Fitting a Different Plug:
The wires in the power cord are colour-
coded as follows:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of these
wires may not correspond with the identify-
ing marks on the plug terminals.
Proceed as follows:
1. Connect the green and yellow (Earth)
wire to the terminal in the plug marked
'E' or with the symbol (
coloured green or green and yellow.
2. Connect the blue (Neutral) wire to the
terminal in the plug marked 'N' or
coloured black.
– Earth
– Neutral
– Live
), or
25