Advertisement
Available languages
Available languages
WARNING!
•
The cylinder valve(s) must be readily accessible for hand operation. A door on the enclosure to gain access
to the cylinder valves is acceptable, provided it is non-locking and can be opened without the use of tools.
•
The enclosure for the LP-gas cylinder must isolate the cylinder from the burner compartment to provide
shielding from radiation, a flame barrier, and protection from foreign material, such as hot drippings. The
enclosure cannot be located directly below the grill.
•
There must be a minimum clearance of 2 in (51 mm) between the floor of the LP-gas cylinder enclosure
and the ground.
•
The enclosure must be designed so that the LP-gas cylinder can be connected, disconnected and the
connections inspected and tested outside the cylinder enclosure. Any connections that can be disturbed
when installing the cylinder in the enclosure must be accessible for testing inside the enclosure.
OPENING
A
5" (127mm)
MAXIMUM
OPENING
B
1" (25.4mm)
MAXIMUM
CYLINDER SIZE
20 lb (9.1kg)
30 lb (13.6kg)
BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping
should be located as shown in the built-in instructions. A flexible metal connector is included to simplify the
installation of the unit. Connect this connector to the flare fitting on the end of the manifold. Connect the
other end of the connector to the gas piping. Ensure that the connector does not pass through a wall, floor,
ceiling or partition, and is protected from damage. Do not use hose to connect the unit. It must be connected
with rigid pipe, copper tube or an approved flexible metal connector which complies with Z21.4 /CSA 6.10.
The installation must comply with CAN B149.1 Natural Gas and Propane Installation Code in Canada, or to the
National Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply pipe must be sufficiently sized to
supply the BTU/h specified on the rating plate, based on the length of the piping run. If installing a side burner,
a separate line must be branched off to the side burner unit and enter the side burner opening at the specified
location.
WARNING!
Built in units are supplied with a drip pan which holds only a minimal amount of grease.
To prevent grease fires, the pan must be cleaned after each use.
WARNING!
Access must be provided to the inside of the enclosure to make gas connections.
DANGER!
Read all instructions carefully before operating the grill. Failure to follow these instructions
exactly could result in a fire causing serious injury or death. The entire installation must be leak tested
before operating the grill.
34" (864mm)
RECOMMENDED
2" (51mm)
MINIMUM
5" (127mm)
MAXIMUM
OPENING A AREA
2
20in
(130cm
2
30in
(195cm
PARTITION TO ISOLATE
CYLINDER FROM GRILL
OPENING B AREA
2
2
2
)
10in
(65cm
)
2
2
2
)
15in
(100cm
)
NON LOCKING DOOR
Advertisement
