Napoleon Gourmet Grill Instruction Manual

BUILT-IN UNIT INSTRUCTION GUIDE
Please use this manual in conjunction with your main manual to properly assemble your built-in grill. Refer to
the main manual for operating, cleaning, and maintenance instructions. This grill is designed for NON-COM-
BUSTIBLE enclosures only, and must be installed and serviced by a qualified installer to local codes.
BUILT IN PROPANE GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as
shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this connector
to the 3/8" flare fitting on the end of the manifold. Connect the other end of the connector to the gas piping. Ensure that the
connector does not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use hose to connect the
unit. It must be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply
with CAN B149.1 Natural Gas and Propane installation code in Canada, or to the National Fuel Gas code, ANSI Z223.1 in the United
States. The minimum recommended piping size is NPS 1/2" for rigid pipe, and 1/2" OD for copper tubing (based on a 20 ft run).
Longer runs may require larger sizes to conform with local codes or to conform with CAN B149.1. Propane Gas Installation Code in
Canada or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply must be connected to the 3/8" flare
elbow fitting located under the right hand side of the control panel. If installing a side burner, a separate line must be branched off to
the side burner unit and enter the side burner opening at the specified location. If the enclosure is to house a propane cylinder, the
tank portion of the enclosure must be ventilated according to local codes, and must not have communication with the cavity used to
enclose the gas grill. A propane tank can not be stored below the gas grill.
BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as
shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this connector
to the 3/8" flare fitting on the end of the manifold. Connect the other end of the connector to the gas piping. Ensure that the connector
does not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use hose to connect the unit. It must
be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with CAN
B149.1 Natural Gas and Propane Installation Code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States.
The minimum recommended piping size is NPS 1/2" for rigid pipe, and 5/8" OD for copper tubing (based on a 20 ft run). Longer
runs may require larger sizes to conform with local codes or to conform with CAN B149.1. Natural Gas Installation Code in Canada
or to the National Fuel Gas Code, ANSI Z223.1 in the United States.
Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires, the pan must
be cleaned after each use.
DANGER: READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING GRILL. FAILURE TO FOLLOW
THESE INSTRUCTIONS EXACTLY COULD RESULT IN A FIRE CAUSING SERIOUS INJURY OR DEATH.
THE ENTIRE INSTALLATION MUST BE LEAK TESTED BEFORE OPERATING THE GRILL.
SERIAL #______________________
N415-0175 / MAR 04/08