Loading Laundry; Adding Detergent And Care Product; Starting The Programme; Changing The Activated "Ready In" Time - Bosch WAU28S80GB User Manual And Installation Instructions

Hide thumbs Also See for WAU28S80GB:
Table of Contents

Advertisement

13.4 Loading laundry
Note: To prevent creasing, take note
of the maximum load for the
→ "Programmes", Page 25.
Requirement: The laundry is pre-
pared.
→ "Laundry", Page 29
Open the door.
1.
Make sure that the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 30.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
13.7 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 30
¡ The "Ready in" time is set and ac-
tivated.
→ "Buttons", Page 23
Press Start/Reload.
1.
The activated "Ready in" time is
paused.
Press Finish in repeatedly until the
2.
display indicates the desired
"Ready in" time.
Press Start/Reload.
3.
The changed "Ready in" time is ac-
tivated.
13.8 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start/Reload.
Basic operation en
31

Advertisement

Table of Contents
loading

Table of Contents