Table of Contents
Advertisement
13.3 Adjusting the pro-
gramme settings
Requirement: A programme has
been set.
→ "Setting a programme", Page 32
Adjust the programme settings.
▶
→ "Buttons", Page 24
Observe the information about op-
erating logic → Page 18.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme", Page 32
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 33
Press and hold Favourite for ap-
▶
prox. 3 seconds.
Press Favourite to call up the
saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 27
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 31
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.7 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 32
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
Basic operation en
33
Advertisement
Table of Contents
