Initial Setup - Sanyo FW65C78F Owner's Manual

These operations are accessible by remote control.
Some may also be accessible by the main unit's control panel.

Initial setup

This section will guide you through the unit's Initial setting which
includes selecting a language for your on-screen menu, country,
location and Autoprogram, which automatically scans and
memorizes viewable channels. You can also set the network
connection in this setting.
Before you begin:
Make sure the unit is connected to an antenna or cable.
1
After making all the necessary connections, press B to turn on
the unit.
It may take a few moments to turn on the unit for the first time.
●
Initial setup menu appears automatically after the unit is
●
turned on.
2
Use H I to select the on-screen language, Voice guide, country,
TV placement and location in the middle of the TV screen, then
press OK.
You must set Home in location setting. Otherwise, Picture
●
and Sound settings you adjusted will not be memorized after
the unit goes into standby mode.
3
Use J K to select Skip or Next on network setup screen.
4
Use H I to select Wireless or Wired, then press OK.
Installation
This TV can be connected to your
home network.
Select your connection type.
1234
Skip
If you have a wireless router, select Wireless to
Wireless
connect to the internet.
If you connect with an Ethernet cable, select
Wired
Wired to connect to the internet.
If you have a router with easy connect function, select
●
Wireless and use J K to select Simple Connect, then press
OK.
5
Follow the on-screen instructions to complete the installation.
When you select On in the selection screen for Software
●
update notification, A message will appear later if there is the
latest software on the network server.
Wireless
Wired
56 7
6
Use H I to select the signal type.
If the TV is connected to a cable or satellite set-top box, select
●
the 2nd one and skip to step 8.
Installation
Select "Antenna" to set up a TV
signal from a cable TV wall jack or
a standard TV antenna.
Select "Set-top box" to set up a TV
signal from a cable TV box or
satellite TV receiver.
1234 56
7
Use H I to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Installation
Make sure that you have attached
your antenna or cable signal into
the jack on the back of your TV
labeled "ANTENNA IN".
Now select either Antenna or
Cable, using up/down key of the
remote control. Once you have
made your selection, press the OK
button to proceed.
1234 56
When Antenna is selected, the TV detects antenna signals.
–
It searches for DTV and analog TV channels available in your
area.
When Cable is selected, the TV detects signals supplied by
–
cable. It searches for DTV, analog TV and cable channels
available in your area.
Auto programming will begin.
●
Installation
System searching. Please wait...
Auto programming may take more
than 20 minutes to complete.
Digital channels will take longer
than Analog to find and program.
Please wait until you see the Auto
Programming complete message.
1234 56
Stop
20 .
English
Antenna
Set-top box
7
Antenna
Cable
Skip
7
Digital channels found: 0
Analog channels found: 0
Total progress:
7
Continued on next page.