Elation SIXPAR 200WMG User Manual page 14

DMX-512 CONTROLLER CONNECTION
Connect the provided XLR cable to the female XLR output of your controller and the
other side to the male XLR input of the SIXPAR 200IP
a typical DMX-512 connection when the fixture is in the 12 Channel Mode. You can
chain multiple panels together through serial linking. Always be sure daisy chain your
in and out data connections, never split or "Y" your DMX connections.
DMX-512 CONNECTION WITH DMX TERMINATOR
A DMX terminator should be used in all DMX lines especially in longer runs. The use of
a terminator may avoid erratic behavior in your DMX line. A terminator is a 120
ohm,1/4 watt resistor that is connected between pins 2 and 3 of a male XLR
connector (DATA + and DATA -). This fixture is inserted in the female XLR connector
of the last fixture in your daisy chain to terminate the line. Using a line terminator will
decrease the possibilities of erratic behavior. Use the SIXPAR
Cap listed in the OPTIONAL ACCESSORIES section at the end of this manual.
w w w . e l a t i o n l i g h t i n g . c o m
™
. The diagram below illustrates
™
DMX Terminator End
SIXPAR 200IP™ User Manual ver