Kenwood ProTalk LT PKT-23LF Instruction Manual page 15

InSTaLLInG ThE BELT CLIP
If necessary, attach the belt clip using
the two supplied M3 x 6 mm screws (with
washers).
Note: If the belt clip is not installed, its mounting location may get
hot during continuous transmission or when left sitting in a hot
environment.
CAUTION
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver's back panel.
ConnECTInG an EaRPhonE/ MICRoPhonE
Connect an earphone/ microphone to the phone jack on the top of
the transceiver.
Note:
◆ Be sure to connect an earphone/ microphone
to the phone jack fully and tightly. If the pin
jack of an earphone/ microphone is not
inserted fully, a pin contacting error will
happen and a noise may occur.
◆ Depending on the sleeve shape of an
earphone/ microphone jack foot, it may be
difficult to judge the inserted condition. Before
using the radio, confirm the Transmit/ Receive
operation with an earphone/ microphone.
◆ To keep the transceiver water resistant, the
phone jack cover must remain closed.
3.5 mm
plug
Phone
jack cover
15