Amcrest IPM-721E User Manual page 100

The first column shows the checkboxes to enable the corresponding service on the table. o The
o
second column shows the name of the services. To edit this, double click on the service line item. o
The third column shows the name of the protocol used by that service. To edit this, click the
pencil button in the modify column for that line item.
o The fourth column shows the Internal Port used by that service to establish communication from the
router to the camera. To edit this, click the pencil button in the modify column for that line item.
o The fifth column shows the External Port used by that service to establish communication from the
router to the internet. To edit this, click the pencil button in the modify column for that line item.
o The sixth column shows the status of the protocol. If the protocol was mapped successfully, this field
will say "Mapping Succeeded".
The seventh column allows the user to open a dialog box and edit the service's information.
o
To see how to setup the camera for remote access, see section 4.7.
To reset to default settings, click the Reset Defaults button. To refresh the page, click the Refresh button. To save
the settings, click the Save button.
100