Operating From A Remote Location - Panasonic KX-FP181 Operating Instructions Manual

Operating from a remote
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (feature #11 on page 66) and set the unit to the TAD/FAX
mode before going out (p. 52).
Dial key Remote command
0
Skips the greeting message
1 Repeats a message
Skips a message
2
New message playback
4
All message playback
5
Re-records a greeting message
7
Continues operation
8
Note:
During remote operation, the unit will stop and two beeps will be heard in the following conditions:
— 2 minutes 40 seconds after your unit answered.
— Every 2 minutes 40 seconds after pressing any command key.
To listen to further messages, press
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
1. Call your unit.
2. Enter the remote operation ID
message.
3. Press the remote command
key(s) within 10 seconds (see
the reverse side).
Remote Operation
8
within 10 seconds after hearing the two beeps.
Answering Device
Remote Operation
during the greeting
The new messages will be
played automatically.
If there are no new
messages, wait for 4
seconds. All the messages
will be played back.
location!
Page Dial key
Stops re-recording of a greeting
9
61
message
Erases a specific message
4
60
Erases all messages
5
60
8 0 Changes to the TEL mode
60
8 1
Turns ON message transfer
60
8 2 Turns OFF message transfer
61
8 3
Turns ON pager call
See
8 4
Turns OFF pager call
note
Notice of Remote Operation
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
When the unit is in the TEL
mode, call your unit and wait
for 10 rings. Enter the remote
operation ID within 8 seconds
and wait for 3 seconds. The
unit will switch to the TAD/FAX
mode.
When you press a key, press
firmly.
To send a document, press
. When a fax tone is
9
heard, start transmission.
(KX-FP185 only)
Remote command Page
61
61
61
61
61
61
61
61
59