Table of Contents
Advertisement
What to do if...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by
calling one of these numbers:
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
– IE 01450 2655
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
The
Start/Stop indicator light
Mains plug plugged in?
does not come on.
Programme selected?
The
symbol and
Start/Stop
Empty the condensation container
indicator light are flashing.
Check the condensation outlet hose, if applicable (kink).
The
symbol and
Start/Stop
Clean the air cooler
indicator light are flashing.
fluff filter
The
symbol flashes.
Is the water tank empty?
Filling with distilled water
The Steam Dry - Steam Refresh
The filter in the water tank may have become dirty.
does not start.
If so, clean the filter in the water tank
Dryer does not start.
Has the
Programme set?
Ambient temperature greater than 5 °C?
Water is leaking out.
Make sure the dryer is level.
Clean the air cooler seal.
The door opens by itself.
Push the door closed until you hear it click into place.
Items crease even though the
Laundry load exceeded?
Steam Dry - Steam Refresh
Remove articles of clothing immediately after the end of the
programme has been selected.
programme, hang up and pull into shape.
Creasing.
Laundry load exceeded?
Remove articles of clothing immediately after the end of the
programme, hang up and pull into shape.
Unsuitable programme selected
Drying result is not satisfactory
Warm laundry feels damper than it actually is.
(laundry feels too damp).
The selected programme does not suit the load. Use another
drying programme or, in addition, select the time programme
Use fine adjustment for the drying result
Fine layer of limescale on the humidity sensors
Programme termination, e.g. tank full, mains power supply
failure, door open or maximum drying time reached.
Drying time too long.
Rinse the fluff filters under running water
Insufficient supply of air
Air inlet possibly blocked
Ambient temperature higher than 35 °C
The humidity in the room increases
Make sure the room is sufficiently ventilated.
significantly.
One or more programme status
Clean the filter and air cooler under running water
indicator lamps are flashing.
Check the installation conditions
Switch off, allow to cool, switch on again and restart the
programme.
The interior light (depending on the
Unplug the appliance plug, fold back the cover cap on the inside
model) does not work.
above the door (using a Torx 20 screwdriver)
and replace the bulb. Close the cover cap.
Page 4.
Page 6 "Cleaning and care". Clean the
Page 4.
Page 9.
Page 4.
Start/Stop button been pressed? Is the door closed?
Page 7.
Page 7.
Page 1/2.
Clean the humidity sensors
Page 6.
Page 4.
ensure that air can circulate.
Clear inlet
Page 10.
ventilate the room.
Page 10.
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– for drying or unwrinkling/refreshing fabrics.
The dryer must
– be used for purposes other than those described above.
NEVER...
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets,
and lighters in particular
– Do not lean or sit on the door
– Open the door carefully. Hot steam may escape. The clothes and drum may
be hot
– Secure loose leads or hoses, otherwise there is a risk of tripping.
Installation
– Below 0 °C there is a possibility of frost damage.
Mains
– Connect the dryer according to specifications to an AC earthed socket,
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead
Operation
– Only laundry must be loaded into the drum.
Before switching on the dryer - check the contents.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.)
– Hazard caused by dust (e.g. coal dust, flour): do not use the dryer
– Do not put laundry containing foamed material/rubber in the dryer
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
– Switch off the dryer once the programme has ended.
– For unwrinkling/refreshing fabrics, use distilled water only. Do not use
condensation, tap water or additives.
– Distilled/condensation water is not for drinking.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use a dryer with a faulty mains lead. To prevent risks, a faulty mains
lead must only be replaced by the after-sales service.
Page 4/6.
– Before changing the bulb of the interior light make absolutely sure you have
pulled the appliance plug from the socket
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
– Dryer: unplug the appliance plug, then cut the mains lead from the appliance.
Disposal
Dispose of the dryer at an approved public disposal facility.
– Packaging: keep all packaging out of reach of babies and children.
– All materials are environmentally safe and recyclable. Dispose of in an
environmentally-responsible manner.
12
risk of explosion.
risk of tipping.
risk of burns.
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
risk of explosion.
danger of suffocation.
elastic
risk of electric shock.
13
Hide quick links:
Advertisement
Table of Contents
