Table of Contents
Advertisement
What to do if ...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales service. We will
always find an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
the manufacturer and rest assured that the repair will be carried out by trained service technicians using
original spare parts. The contact details of your local after-sales service can be found in the enclosed after-
sales service directory.
When contacting the after-sales service, please quote the appliance's product number (E no.) and
production number (FD) (see the inside of the door).
Set the programme selector to Aus/Arrêt (Off) and remove the appliance plug from the socket.
The
Start/Stop indicator lamp
Mains plug plugged in?
does not light up.
Programme selected?
Check the socket fuse.
The display panel light and indicator
Energy-saving mode is activated
lights (depending on model) go out
Energy-saving mode instructions.
and the
Start/Stop indicator light
flashes.
The
symbol and
Start/Stop
Empty container for condensation
indicator lamp flash.
Clean the condensate container filter if necessary
Each time the dryer is transported, you must wait two hours before
operating it.
The
symbol and
Start/Stop
Rinse the fluff filter under running water
indicator lamp flash.
Dryer does not start.
Door closed?
Programme set?
Ambient temperature greater than 5 °C?
Water is leaking out.
Make sure the dryer is level.
The door opens by itself.
Push the door closed until you hear it click into place.
Creasing.
Laundry load exceeded?
Remove articles of clothing immediately after the end of the
programme, hang up and pull into shape.
Unsuitable programme selected
Laundry is not dried correctly or is still
After the end of the programme, warm laundry feels damper than it
too damp.
actually is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but
does not increase the temperature. Your laundry will become drier.
Select a programme with a longer drying time or increase the
drying level. This does not increase the temperature.
Select a time programme for extended drying of laundry that is still
damp .
If you have exceeded the maximum load for the programme, the
laundry may not be dried correctly.
Clean the moisture sensor in the drum. A fine layer of limescale
may adversely affect the performance of the sensors and your
washing will not dry properly .
Drying has been interrupted as a result of a power cut, because the
condensate container is full or because the maximum drying time
has been exceeded.
Drying time too long.
Rinse the fluff filters under running water
Insufficient supply of air
Air inlet possibly blocked
Ambient temperature higher than 35 °C
The humidity in the room increases
Make sure the room is sufficiently ventilated.
significantly.
Cln appears in the display panel.
Not an error! Automatic cleaning of the heat exchanger.
Do not empty the condensate container.
Power failure.
Remove the laundry from the dryer immediately and spread it out.
Heat may escape. Be careful as the door, the drum and the laundry
may be hot.
Other intermittent noises and
Not an error!
vibrations.
Normal noises
Loud humming noise for several
Has the condensate container been properly reinserted?
seconds.
Not an error! Normal noises
see the separate
see page 4.
Page 4.
Start/Stop button selected?
Page 7.
Page 4.
ensure that air can circulate.
Clear inlet
Page 8.
ventilate the room.
Page 11.
Push the condensate container all the way in.
Page 11.
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
– be used for purposes other than those described above.
The dryer
must NEVER...
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been instructed
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
– Do not lean or sit on the door
Installation
– Secure loose cables
– Do not operate the dryer where there is a risk of frost.
Page 9.
Mains
– Connect the dryer according to specifications to an AC earthed socket,
connection
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead
Operation
– Only laundry must be loaded into the drum.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
– The tumble dryer is not to be used if industrial chemicals have been used for
– Hazard caused by dust (e.g. coal dust, flour): do not use the dryer
– Do not turn off the dryer until the drying process ends, unless the laundry will be
– Do not put laundry containing foamed material/rubber in the dryer
– Light things, such as long hair, may be sucked into the air inlet of the dryer
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to
– Switch off the dryer once the programme has ended.
– The water from condensation is not drinking water and may be contaminated
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
– Do not use a dryer with a faulty mains lead. To prevent risks, a faulty mains lead
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: unplug the appliance plug, then cut the mains lead from the appliance.
– The dryer's heat exchanger contains fluorinated greenhouse (R134a) gas
– Packaging: keep all packaging out of reach of babies and children.
– All materials are environmentally safe and recyclable.
12
in its use.
Pay particular attention to cigarette lighters
Risk of tipping.
Tripping hazard.
otherwise it cannot be guaranteed that the appliance is completely safe.
Risk of electric shock.
Risk of electric shock.
Before switching on the dryer - check the contents.
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.)
Fire/explosion hazard.
cleaning.
Risk of explosion!
removed quickly and spread out, so that the heat can dissipate.
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
Risk of injury.
ensure that the items are left at a temperature that ensures that the items will not
be damaged.
with fluff.
Repairs must only be carried out by the after-sales service.
must only be replaced by the after-sales service.
Dispose of the dryer at an approved public disposal facility.
in a hermetically sealed unit
dispose of in a proper manner.
Capacity: 0.22 kg.
Danger of suffocation!
Dispose of in an environmentally-responsible manner.
Risk of explosion
elastic
13
Advertisement
Table of Contents
