Before using your washer-dryer for the first
time
Preparing your
washer-dryer
12
Caution
The washer-dryer must have been installed and
connected properly (refer to page 53).
² The washer-dryer was tested before leaving the
factory. To remove any water left over from testing
procedures, the first washing cycle should be
carried out without laundry in the machine.
Turn the tap on.
■
Pull out the detergent drawer all the way.
■
Pour approx. 1 litre of water into chamber II of the
■
detergent dispenser.
Half fill the measuring beaker with detergent and
■
pour into chamber II.
² Do not use any special detergents for delicates or
woollens (excessive foam).
Close the detergent drawer.
■
Close the washer-dryer door.
■
Set the programme selector to Cottons ic with
■
washing temperature 90°C.
Touch the Start/Pause A button. The programme
■
starts.
The programme ends when the programme duration is
on -0-:
Turn the programme selector to Off.
■